AkronTony Posted April 25, 2019 Report Share Posted April 25, 2019 In the past, I have found that some plastic figures react differently to the primers I have used. In one case, the figure became very sticky and it took about a week to dry. What primer have you had success with for the Monolith figures? Thought I would ask before I just jumped into things. Tony Quote Link to comment Share on other sites More sharing options...
Not Quite Dead Posted April 25, 2019 Report Share Posted April 25, 2019 (edited) Hi there and welcome, Tony! Since two years now, I use Molotow Premium Spray to prime my miniatures. I like them better than the Citadel one who had sometimes strange effects when I was priming when the weather was too hot. I have currently a 400ml spray can Grey Blue Middle (#226, Art.-Nr. 327178) but you can pick any color that suits you better. They've got varnish too, if you plan to use one after you've painted your miniatures. Mine is called clear coat matt (#253, Art.-Nr. 327313). Edited April 25, 2019 by Not Quite Dead Spelling. 2 Quote Link to comment Share on other sites More sharing options...
garbetsp Posted April 25, 2019 Report Share Posted April 25, 2019 I use my basement in the summer because spray priming in the heat is a bad idea. Quote Link to comment Share on other sites More sharing options...
Not Quite Dead Posted April 26, 2019 Report Share Posted April 26, 2019 I always prime outside, which force me from time to time to wait days to do it, due to the temperature, as I always feared that priming inside was bad for lungs. Do you wear a mask or something? 1 Quote Link to comment Share on other sites More sharing options...
AkronTony Posted April 26, 2019 Author Report Share Posted April 26, 2019 Thanks for the information. 1 Quote Link to comment Share on other sites More sharing options...
garbetsp Posted April 26, 2019 Report Share Posted April 26, 2019 14 hours ago, Not Quite Dead said: I always prime outside, which force me from time to time to wait days to do it, due to the temperature, as I always feared that priming inside was bad for lungs. Do you wear a mask or something? No just have a large basement in an old house that's very drafty (sucks on heating bills). I spray and run. Come back later. I would wager there are lung effects, but it's a lot less than smoking. Lungs are designed to be able to expel some contaminant exposure without much issue (nicotine suppresses that effect). I think the principal risk is the propellant/solvent typically used causes permanent brain damage and a basic mask will not block this. Even a little bit of that is not to be trifled with. I think the air brush folks use a different solvent that doesn't do this, but to dispense from a spray can it's basically required. You are right to be cautious. Go with that. 1 1 Quote Link to comment Share on other sites More sharing options...
Epaka Posted April 27, 2019 Report Share Posted April 27, 2019 You can pick up a decent respirator mask at any hardware store with replaceable filters designed for small particulates or chemicals. I have a workshop area in my garage with fans and a ventilating system so I can prime or spray paint year round in a controlled environment. But however you go at it, definitely pay attention to excessive heat/cold and humidity, as that can adversely affect spray paint/primer. 2 Quote Link to comment Share on other sites More sharing options...
garbetsp Posted April 27, 2019 Report Share Posted April 27, 2019 I looked up the mask requirements for this situation and it says the following "use one approved by National Institute for Occupational Safety and Health (NIOSH) and are fitted with organic vapor (ov) cartridges." Quote Link to comment Share on other sites More sharing options...
Epaka Posted April 27, 2019 Report Share Posted April 27, 2019 Yup. Amazon, or almost any hardware store should have them. Inexpensive, and effective. Better safe than sorry I think. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.